Measuring Block groups 017, 018, 019 and 020 should show Battery information.Providing the value was accepted by the controller the new battery coding is complete. Note, the New value must be 26 (alpha numeric) total characters including the spaces! If in doubt check the saved log for the original battery formatting details.Type the New Battery details into the New value field. Saving the original value to a log is strongly recommended. VCDS will populate instructions in the form of a pop-up balloon with the formatting.
Follow the on-screen instructions to enter the Part Number, Vendor, and Serial Number all as one long new value. Installation of a new battery requires the use of the function under 19-CAN-Gateway control module. This procedure applies to battery replacement in vehicles using a battery management control module that is a slave/subsystem of the CAN Gateway.Īddress 19: CAN Gateway (J533) Labels: 8T0-907-468.clb In these cases, the new battery information is entered in 61-Battery Regulation then Adaptation Channel 004. Some vehicles like Audi R8 along with some rest-of-world models with Stop-Start, can have a 61 that is really a virtual module in the 19-CAN Gateway.Your new Battery should now be coded and the Battery Control Module should be aware of the new Battery.